Free Shipping On All Orders Over £150 / Discreet Packaging
Free Shipping On All Orders Over £150 / Discreet Packaging

Currency

Skip to content
Cart (£0.00)

Your cart

Your cart is empty

Helpful Tips For Your Electric Shock Chastity Cage

These instructions work for all of the HOC600 Shocker cage ranges, including  Design 1, Design 2 and kit chastity cages, Air One E-Stim and The Loc'd Electric Shock Kit.

The HOC600 Shocker Design 1 is shown below to help with assembly.

The 600HOC shocker is pictured in clear, it is similar to the CB6000, yet it has detachable electronic pads that allow the wearer to receive electric shocks. The control panel is also shown.

For assembly below is an image of the Air One E-Stim chastity cage, it is shown fully assembled and with the shock conductors fitted in place.

For those customers that are in receipt of a chastity cage with a urethral and base ring shock conductor, please see the image below to see where to insert the wiring kit.

Warnings Before Use:

  • Before and after use please clean all parts of device that come into contact with the body with warm water, and regularly disinfect them with 75% medical alcohol.
  • Lubricate the interior of the device to allow the penis to move freely and to avoid rubbing.
  • Patients with heart disease or those using pace makers are prohibited from using the devices.
  • These devices are designed to be used by persons over 18 only, persons under 18 are prohibited from using the devices.
  • Please do not disassemble or modify the products to avoid any harm to the body caused by an abnormal product.
  • Although these electric shock chastity cages are highly stimulating sex toys, the product design complies fully with safety standards and can be used with confidence.

Handset Description:

Instructions:
  1. Install 2 x AAA batteries into the hand control
  2. Install the wire connector into the handset (remember: this accessory must be used with two wires, with both the positive and negative poles inserted into the chastity cage so that the conductors have contact with the body).
  3. Press and hold the power button for 3 seconds, the power light indicator will remain on, and the handset will be turned on.
  4. To select a function, press the function key once and the indicator light will flash, indicating successful selection of the function.
  5. Turn the scroll button to slowly adjust the intensity of the pulse, turning up will decrease, turning down will increase the pulse.
  6. It is recommended to send electrical pulses to the same area of the body for no more than 15 minutes.
  7. Remove batteries after use.
  8. Accessories that come into contact with private parts should be cleaned, wiped dry, disinfected, and stored in a cool dry place for future use.

Previous post
Next post
Back to Education, Advice, Fun & Games

Leave a comment

Please note, comments must be approved before they are published